pasquot

i kind of had the same problem with 357 sig brass. they would not chanber after loading. what worked for me was to resize the brass again after loading. try one or two to see what happens

update and final.. as it turned out what i had to do is resize with a 40 sizing die after loading. apparently the 357 barrel is tighter than the 40 b thank u to all who responded to my request .

thanks. i will try the plunk test

ordered guage, post office claimed it got my mail box, never saw it. i will try oal to see if that has any effect. i do resize with a 40 die 1st. no bulge issues . they will fit into a 40 barrel

i have been loading 357 sig for several years but not volume. i just made too many new rounds and now every round i have to push the barrel forward to go into battery. no setting have been changed. would like suggestions. gun is sig 2340

i went from 223 with large power bar to 9mm with small bar. as far as i know the die and falisafe rod are adjusted properly. when loading 9mm instead of 4,7 gr it overflows the case. i emailed dillon. no response yet any suggestions would be holfful btw. the small power bar soes seem to me to be defectuve, it appers to me the adjustment screw is not wroking properly

thank you for that information. i do have small primer set up correctly.

thank you gentlemen for all your suggestions. i took all the dies and the dillon powder die out and started over. once again i had trouble adjusting the powder die for full tavel and expanding the case but sucess. it works now. i was able to make some quality bullets after i ruined a few. now if could just get all the primers to seat instead of upside down or sideways i will be in good shape.. once again thank you all.

i need to make a correction on dies. i am using lee dies in station 1 and station 3 but i am using dillon powder die set up in station 2. please keep suggestions comming. thank you.

i have a used 550b. attempting to set up 380 dies from scratch with lee dies. i had a terable time setting up the powder die for max powder flow and bell. i believe i got it now. the problem comes when i attempt to seat the bullet. no matter where i adjust the seating die the powder die will not allow me to raise the platform to seat the bullet. i have watched youtube vedeos and i understand how it works. but in reaity im doing something wrong. i havent seen that problem on video.. please assist