zx9rt1

What do us Tanfo owners do for spare slides here in the states? I have the Eric Gold open pistol that’s getting close to 60k down range. Making me a bit nervous Are they trying to make me go back to CZ?

Well this is a little concerning. I have a couple of their higher end pistols.

Good morning everyone! I need some help with a new Tanfoglio Gold Match I picked up the other day. The trigger on the pistol needs a good working over. I currently shoot a Czechmate and I’m wanting to get the Tanfoglio trigger as close I can to the Czechmate. The Tanfoglio has a trigger break that averages a little over 5 pounds which to me is a tad too high considering what I’m used too. Does anyone have a list of parts that would need to be replaced to get her going in the right direction? I emailed Patriot a couple of days ago and have not received a reply. So now I turn to the ones that have experience with the Tanfoglio Gold Match. It’s a new pistol stamped “2020” under the the left side thumb safety. I’m looking to get the trigger break under 2 pounds. My Czechmate is consistent with 1 lb 6 ounce trigger out of the box. Im a bit disappointed with the Tanfoglio’s trigger especially since it’s an open pistol. However, I believe she has the potential to be a good runner. Please let me know of some suggestions if you can. Have a great day and be safe! Michael

Disregard. Wrong forum. Not a Beretta

Wrong Forum. Disregard

I replace the hammer, firing pin, and recoil springs on my Tanfoglio Limited right around the 15k mark. I have approximately 40k through mine so far and had to replace my sear and hammer due to hammer follow at 30k. Other than that, that's it. You may want to take into consideration on how "hot" your loads are. Mine are on the softer side since I only shoot reloads. I'm sure someone will be here shortly to chime in. Sent from my iPhone using Tapatalk

johnbu. I just lob 'me right in there. Kinda like a mortar[emoji23] The one on the left sits high too. Sent from my iPhone using Tapatalk

Works like a champ! Sent from my iPhone using Tapatalk

Replied. Thank you! Sent from my iPhone using Tapatalk

Thanks. Sent from my iPhone using Tapatalk

How's the slide to mount clearance on it? Sent from my iPhone using Tapatalk

I was looking at that one pretty hard but was worried about the ejection port to mount clearance. I may just go ahead and give it a try to see how it does. Sent from my iPhone using Tapatalk

Good morning all! I have a Elite Match in 45acp that I'm wanting to put a C-more rail dot on without having to drill and tap the frame. Any suggestions? Sent from my iPhone using Tapatalk

Congrats! That's tough to get Sent from my iPhone using Tapatalk

I looked at the speed ledge as well but think I'll be in the same boat. Sent from my iPhone using Tapatalk