WmKerle

I have gotten a lot of them now in the bulk brass I buy form an indoor range. I load on a XL650 and use an RCBS 9mm die and just punch the flash hole out to the larger size.

Yes that's my favorite powder for 10mm and yes it is a flashy powder .... I run a little bit more than that in my loads but I did start out lower and worked my way up with a chronograph.

When I was still shooting limited division my go to was 155gr Blue Bullets over e3.

I have a Sig Max and use the .355 125gr blues and they group good for me.

I have it on my XDM 5.25 9mm and use it in USPSPA in the Co. Division works great. I will say use red loctite on it not blue.

I use it in 9mm .40s&w and 45acp. I've got 40+ lbs of it. e3 is my go to powder for handgun reloading. You can use the reddot chart start low and work you way up with a chronograph

Well I have an XDM 5.25 with a vortex venom on it. I'm using 125gr Blue Bullets with 3.6gr of e3 with a COL of 1.100 and makes 140PF. The gun has a 14# recoil spring and PRP extreme trigger kit. I know e3 is a fast powder but I don't think it's a big charge. Gun runs 100%

Updated I received my shipment of Blue Bullets today. So total time was 6/16/20 to 9/5/20

I placed an order on 6/16/20 and got a shipping number yesterday. The item still has not moved in the USPS system yet.

I'm running the Blue Bullets 125gr with e3 @ 3.6gr. My col is 1.100 with a 143pf out of my XDM 5.25

I'm running 125gr RN Blue Bullets with 3.6gr of e3 at 1.090 OAL. You will need to chronograph your own because you may have +/- of a powder changed to make power factor.

I have an XDM 5.25 setup for CO. When I started factory ammo was a no go. Did the same thing you are saying in this thread. Had to go to an OAL of 1.090 the big thing was droping the powder changed down because of the short OAL.

That's a good thing . Are you using a GRx die ? I run all my .40 S&W and 10mm brass through it before I load them. I get a lot of Glock brass from a range and it has the Glock smile on some of the .40 and 10mm I get. I never tried it with out the GRx die.

I got some brass that looked like that .... I ran it through a Redding GRx die first and had no problems loading it afterwards. I never really knew what it was shot out of .... but an HK sounds ok to me.

CR Speed Versa Mag Pouch they work for my XDM 45 mags