Have many of you completely field stripped your 2011 to find (forgive me for not knowing the proper term) the eye bolt on the frame for the trigger screw broken off?
When I bent it up I think the angle was to steep and wouldn’t let it fall. Seems like the same issue you stated. I’ll try it. Thank you.
I tried to load primers while the mark 7 was running but I must have been to slow as powder covered my machine.
A few times it didn’t prime a case which I’m guessing I need to adjust the press or maybe smoothing the primer bar ?
Anyone have issues with primer sense? I adjusted it but doesn’t seem to acknowledge when the primers are empty.
I have weight on the primer rod, I bent the warning bar upward but still doesn’t seem to be catching? Any tricks
You are correct sir. I was thinking that but wrote it incorrect. Thank you.
What about the springs in comparison to the FPS of the loads (major vs minor loads).
This may have been asked 1000 times but I can’t seem to find the answer or I just don’t grasp it. Probably both.
In theory the recoil spring if you change the 10 pound spring which is currently in my 2011 to an 8 for the 9mm
This would be better suited for my “bunny fart” aka low FPS loads. Although the 8lb will still run the hotter load malfunctions can occur with the lighter spring along with the heavier loads hammering the slide back into battery.
I’m just making sure my mind is right
The primer sensor still works even with the RF 100 ?
Bullet sense: keeps powder out of the completed bin, how ? Is it hard to set up. Sorry for all the questions. Easier to talk to someone who has it.
So it will catch that 380 mixed in with 9mm.