Jump to content
Brian Enos's Forums... Maku mozo!

kissingyoubaby

Members
  • Posts

    7
  • Joined

  • Last visited

Profile Information

  • Gender
    Not Telling
  • Location
    Redondo Beach, CA
  • Real Name
    Randall Ng

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

kissingyoubaby's Achievements

Looks for Range

Looks for Range (1/11)

  1. Could be the spring binding on the guide rod. Which way is the spring installed on the guide rod? Should be "flat side" down with the open coil towards the reverse plug. Speaking of reverse plug, was that changed as well? Does the reverse plug hole seem to be too large where a coil could get stuck?
  2. Sure. You can also buy one for around $1. I ran my gun with a broken one for about 4 months till I finally replaced it.
  3. It's an old school 160mm svi mag tube. Should hold around 28 rounds.
  4. You can swap the springs out a month before a big match if you believe in Murphy's law. Else I'll run them till I get a nose dive due to the spring being too weak to push the next round up during live fire.
  5. So there is no question it's a tti follower... As mentioned by Desmo, take the slide off and grind that tab till it stops hitting the slide stop. If you don't change out your slide stop with a Brazo's one, you'll need to take a lot of material off the follower. Don't worry about screwing up the follower, you can always replace it. Should run about $9.
  6. grams one You may need to grind the slide stop as well to prevent slide lock Edited to indicate it's a grams follower
×
×
  • Create New...