Beven was waiting on a new reamer when I talked to him a few weeks ago, might have received it by now. I've also had my CZ barrel reamed by Matt Cheely, no problems.
Also have been rocking KODI for a few years (actually XBMC before switched to KODI). I mostly use Phoenix for HD movies now. Can't believe how many people have never heard of it.
My SP-01 runs 100% on WSP primers as well as any factory ammo I've tried using the 11.5# spring. Only note on that is I have extensively polished everything. Just dropping parts in vs parts AND polishing makes a big difference.
Hey TJART can you mic your extended FPB?
Stand by...
Ok thanks. I measured my extended FPB and came up with 0.508" also. However with hammer back I can still push firing pin in?
That would mean I have not removed enough materials, because neither DA nor SA hammer has ever fallen.How does the new T3 wedge part look now compared to the stock interrupter? Still a lot thicker?
Also I could be wrong but I would think if the hammer isn't dropping you would need to remove more material. I think the more material you remove, it will lengthen the SA pre-travel. So if you remove a lot it will be the same as stock.