jon49erfan

DAA just put out ELS adaptors for their mag pouches.

I had this same problem with an anodized upper. Could only get a BA barrel about 1/3 of the way in a Seekins upper. I froze the barrel for about 2 hours and it went in significantly further and a few taps with a dead blow seated it. On the plus side, no loc tite on the extension was needed.

Dan Wesson PM9. I never should have sold mine.

I've used a ckye in a match. It worked well. Quick mounting and super versatile

Gotcha. I know the MBX tubes are shorter so their base pads are 7mm. Just making sure STI didnt change

Will that fit a gauge with 7mm base pads?

I like scoop. I can put my knuckle in there and rack the slide. I used to use the rear sight to rack my Tac Sport so it was an easy swap for me.

Reciprocating weight vs static weight.

I was all about the VTAC until I used Colorado Precision cuff sling. It has the quick adjustment like a VTAC but it's also cuff sling and all the fasteners are metal.

Wasn't it a 126mm mag too? I'd rather the CK with no mags over an edge with 1 mag I'll never use.

Because its replacement is $800 more.

Every match I've shot, if it has a lens, it's an optic. The SeeAll sight and the Trijicon RX30 would fall into that category too.

Hows the size compared to the PT evo or other metal grips?

That looks really good.