Jump to content
Brian Enos's Forums... Maku mozo!

RexKramer

Classified
  • Posts

    157
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    Easton PA
  • Real Name
    Chris Carney

Recent Profile Visitors

888 profile views

RexKramer's Achievements

Finally read the FAQs

Finally read the FAQs (3/11)

  1. Thank you yeah I was just coming to that realization.
  2. I was able to heat it up with a heat gun and pop it off (nearly literally... nothing nothing nothing BAM loose). My next conundrum is installing the Smoke hand guard. Easy enough, except when the barrel nut is installed it leaves the hand guard canted a little so the mlock slots aren't at 12/3/6/9. More like 11:30 or 12:30 for the top one as an example. I haven't torqued down on it hard, but I don't think it's really going to move much more as it's at the barrel already.
  3. My overlapping hobbis provides me access to a heat gun from RC airplane covering.
  4. Thanks that was my next step. I just want to make sure I'm not missing anything to remove the hand guard once I get to the point of using the JP adapter nut tool with a wrench.
  5. Ok I'm an idiot with a side of moron, so I'm having trouble replacing the Mark III hand guard from my GMR-15 with a Smoke. My issue so far is actually getting the hand guard assembly off. I have the hand guard off, but when using the barrel nut adapter, I cannot get the nut to budge. What am I missing? Besides common sense. Thanks!
  6. When I picture bump firing, shooting a PCC doesn't come to mind. Just get on the trigger.
  7. The 6-32 x 3/8 seem to work like a champ. Just need to put a dab of locktite on them.
  8. Thanks for the replies, guys. And yeah CZC gave me the same answer they gave TommyK up there.
  9. Oh I know. I plan on emailing them, but I was just wondering if anyone here knew. It's amazing how fast you can get an answer.
  10. I have a S2 slide that I just picked up and I want to put a SRO on it. It has the CZC mounting plate, but the SRO's screws are too long to fit properly. I could, of course ask CZC, but what fun would that be? Does anyone know what size/pitch screws the SRO takes and what the length would need to be to properly fit to the CZC mounting plate that's on the S2 slide?
  11. RexKramer

    Accu Shadow 2

    Well stated [emoji16][emoji106]
  12. I have one that I've played with only a little. One thing I did notice is you need a stock hammer spring to make it reliable. If you have a lighter one, you'll get some light strikes. Can't recall the racking force, unfortunately. It didn't stand out as being strong.
  13. I read (yeah one of the worst phrases to use) that fast burning powders such as N320 and Titegroup will be fully burned by the time the bullet gets to the end of a 14.5/16" barrel. The thread was originally discussing the best brakes for PCC and came to the conclusion that even with slow burning powders there wasn't too much "oomph" from the gas at the end of a long 9mm barrel. Obviously there is gas coming out, but it's not enough to work a brake to much effectiveness. During the course of that discussion a few people were talking about velocity loss with fast powders and longer barrels. Now exactly how long a barrel needs to be to have this happen with a certain load work up? I have no idea. To test it you'd need two rifles that are identical other than the barrel length. Say a 8" and 16" barrel. Maybe even a 12" barrel in between.
×
×
  • Create New...