Jump to content
Brian Enos's Forums... Maku mozo!

BOOST

Classified
  • Posts

    177
  • Joined

  • Last visited

About BOOST

  • Birthday 03/13/1973

Profile Information

  • Gender
    Male
  • Location
    Honolulu
  • Interests
    USPSA , IPSC , PPSA
  • Real Name
    Derick Gutierrez

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

BOOST's Achievements

Finally read the FAQs

Finally read the FAQs (3/11)

  1. Has anyone seen these fail, rear cap pop out? I notice that know carbon fiber is supposed to be stronger than aluminum but i can't help to notice that the rear is capped by adhesive. I have two different brands on hand and they are both the same. I wouldn't be concerned if the tube is one piece with the rear.
  2. Colt mags are set backed farther from the barrel than Glock mags. I am guessing this is why Glock set up is better. Glock dont need ramped barrel or ramp on the lower or ramp at the top. I've stayed away from PCC, pre-2015 because all i saw was malfunctions(Colt mags). Colts can be made to run, but i wouldn't even mess with it.
  3. I've got a Syrac that wont adj. Switched to SLR,good stuff.
  4. Golf has no timer. And it's like watching grass grow
  5. BOOST

    shirt idea

    i think i can make some $$ selling shirts with the name "IDOL" on the back. No matter where i shoot, someone's name is "IDOL"
  6. +1. Yeah, ALL of us Senior's agree 64%. Oops, no, we agree 127%. Nope, it's closer to 94%, if I recall correctly. What was the dang question, again? "it doesn't prove you're a good shooter." I think you could say the same thing about running and stage planning and etc. , but just shooting would get boring I think. I hate to admit it after cussing memory stages for my first 3 years, but now I like to see one now and then. Still do not like memory matches though, too much like working. Sounds like ya all just exposed your weakness. That's sad.
  7. What is benelli extractor part # that you're using to swap out on your Stoeger? 60177 or 70037 ?
  8. When ordering from Bladetech, you could request to have a taller sight channel.
  9. Got them on my G34 & G35. I like them better than any other sights . The do rust though. The bluing doesn't help. Dawson should have their sights nitride bath. Or stainless like TTI.
  10. Do you know the gas port size of your Noveske ? I found that LilGun works well with subs in pistol gas system with .090 gas port or higher. Some pistol gas barrels have small gas ports , I found a 14".5 with a .075 port that would eject and not strip the next round. Drilled the port out to .110 and I got the bolt to lock. I'm assuming the smaller ports was meant for factory sub ammo that uses slower burning powder at the same time balancing for supers......or use with a suppressor.
  11. We have carbine matches maxed at 75yds . Majority of the targets within 50. I would like to make matches that have steel and also use them to activate movers. There's enough participants with 9mm and 300BLK AR's.
  12. 300BLK with TGIC powder coated bullets. Without coating I was still able to keep the barrel from leading so long the bullet was properly sized ,up to 1700fps.But gas tube and bcg got some. NiB-x bcg cleans easy. $10 Gas tube every 10K. But since I started powder coating , cleaning is no different than my 223 AR's with jacketed bullets.
×
×
  • Create New...