xracer

Has anyone had their M&P 5" M2.0 slide milled for an optic? RMR, Vortex etc. I have the first version with the top loaded chamber indicator and was wondering what they do with that when they mill the slide. Also interested in other mods that can be done without breaking the bank.

My 5 inch M 2.0 front sight appears to be .160" measured adjacent to the white dot (back of the sight).

They may have raised the price some but not 15%. They were or are also offering free shipping along with the 15% off. I compared to Berry's and Ranier on Midway and both are more. I paid $39 for each of two boxes of 500 for 124gr 9mm and $55 for each of two boxes of 500 230gr 45ACP. So for $188 I got 1000 124gr 9mm and 1000 230gr 45ACP, not too bad.

I think its funny when I try to load sp into lp cases I do it by hand and try three or four times before I figure it out. Don't like the other way around. I separate the brass and when I run out of lp casings I switch over to sp.

Normally I clean out the range stall before I start shooting and only pick up the brass From what my friends and I shot. I don't know how I got so many of these.

Think I'll load it and red marker it so I don't pick it back up. Others seem to feel the same way about it. Does it come as a loaded round or do you buy it to reload? I don't recall seeing this brand at any stores that I frequent.

Anyone have experience with A-Merc stamped brass in 45 ACP? I must have picked up a bunch (50pcs or so) at the range at some point. I can tell immediately when priming that it is this A-Merc brass, it has very loose primer pockets... Not sure if I'm going to load or shoot it...

I shoot my M&P 45 FS better than any other handgun I've ever shot. Its a one ragged hole in ten rounds gun. Unfortunately I don't shoot that well with every gun.

Would have thought that the reamers would have been designed to bottom at the correct depth and bevel?? Guess not.

That's what I was thinking, anyone else seen reamers cut in this much?

I used my Lyman pocket reamer by hand and did not remove much material, also had issues with a half a dozen primers not fitting in the pocket. Yesterday I stuck the reamer in a drill and was shocked at how much material it removed a reamer is designed to run all the way in and the resulting bevele in the pocket is ok? Seems like it removed quite a bit of material.

Thanks, actually there are 500 and they are only 250gr. Will be shooting them out of an Uberti EL Patron SAA clone so I won't be shooting them too fast. Not going to be happy if I have a leading issue though.

I received 50 of these today and half the blue wax rings have broken up and fallen out, how big an issue is this or is it a total loss and I need to send them to you now for disposal.

I'm right in there as well, 230 gr Extremes with 4.5-4.6gr of titegroup at 1.255".