Need some help with a load for 150gr.Hornady FMJ's. Powders to work with are TAC, Varget, and H335. Just don't have a lot of time to mess with it. 18" Seekins SP10. Good accuracy but gamer load.
Check and make sure the primer slide rod that is attached to the primer magazine tube does not contact the bottom of the slide groove before the slide is fully in position.
If you are talking about add-on items for the 650 that's one thing but you could literally go on and on with what you asked. But in general take your time and be diligent about your process. If something doesn't feel right or look right stop and figure it out.
Buy the caliber conversion kit for 9mm. Since you will need everything in it. ie the shell plate locator buttons powder funnel( goes inside the powder die) case feed adapter I think it's green. You may need a small pistol case feed ate too. Dillon recapping pins are different than lee. Lock rings just use the ones on the lee dies. You want the primer seater tight. Use a box end wrench. An the case feed tube is the same.
You can use the data from a similar projectile to the one you are using that has data. Just remember to always error on the side of caution and work up to the target load.
Guys for the ops original question the way I read it Pat gave the best answer. All loading manual have the data for the projectiles he it talking about.