Hello everyone! Here are some problems or issues i found First is the corrosion problem. The beavertail corroded easily. There is also a part in the slide near the serrations that easily gets a corrosion. The ceracote coating should have been thicker. Stock III Special has a better coating/finish Second is the xtreme basepads getting stucked in the magwell or magazine back lip at the ejector. When a new magazine was inserted with force it gets stucked. These mostly happens during insertion of a new magazine in slide lock/empty chamber position. I used a wider custom basepad to eliminate the problem. Third is the barrel. I guess some xtreme model has this problem but none on the regular stock models. There were chippings/deformations on the upper sides of the barrel ramp near the chamber. I do not know what is causing it to chip/deform. This issue never happened on my friends regular stock2 Fourth was the sights. It is not zeroed from the factory. It needed 12 clicks for me before it reached the right spot. The screw for adjusting the elevation should have been longer. There is a chance that the elevation screw might pop-out/release from its position because of the adjustment Fifth was the magazine holes. Holes and other edges was sharp and peep holes should have been exactly for 10, 15 and 17 rounds
I love the old guncase of the regular stock 2. The case that comes with the xtreme was too big.
Single action becomes incredible when upgraded to titan hammer, light hammer and firing pin springs